arrowtronic
-
casadelwhacko posted an update in the group
7 months agoAsk a Grow Question 7 months agoWith the arrival and set up of the new 4×4, I decided to turn the 2×2 into a propagation chamber. I tried cloning before with no success, but want to get up to speed for when these two Strawberry Cough I just topped get a bit bigger, so I can play Johnny Appleseed with a few.
three in coco and worm castings with a sprinkle of Recharge and Dots…
eazeandlax, vancerefridgeration and 5 others9 Comments-
I like coco better, perlite doesn’t hold enough moisture, those coco coins are good. Its that air moisture ratio, damp, not wet. Low, low lighr, like real low or they try and grow and die, 80%. 75 F. Did I mention light? LEDs we typically use are too bright, i used to use burned out florescence lights and now a 10watt bar 24 inches…
3- View 3 replies
-
I wholeheartedly agree with @moistcube. One thing is the temp can go up to 80 if you have the humidity at 80 as well. Mine seem to root quicker a few degrees warmer.
If you use Clonex gel, it will help speed up the rooting.
2- View 2 replies
-
3.5 PPFD. Measured it with the PAR meter
1 -
In almost the same situation here. I decided to go the aero cloner route and built one out of a 2 gal home depot bucket, 1/2″ pvc, an ac infinity 230 gph pump and 6 spray emitter getting 2 more emitters to even out the spray. This has been running with a little bit of clonex and distilled tap water for ten days now and the cuttings haven’t…
1
-
