-
What did you end up getting? I’m using Coco Loco right now and I’m liking it more than Happy Frog, so far. I’d like to do just Coc, just need to get some.
terpyten -
slamfm posted an update 5 months ago
Some buds from the LSD-25. This stuff gives me a nod very similar to heroin, like falling asleep sitting at my computer. Not a user now but you never forget what heroin feels like.
laidbackstoner, wraiths1 and plantparenthood-
Not sure really what I was getting back then half the time. But got a hit of acid the size of a postage stamp once called lsd 25. Was supposed to be pure lsd. Was the cleanest trip I ever had.
1- View 4 replies
-
-
Will it open up? I’ve not seen a seedling do this yet. It almost looks like there isn’t two leaves there, only a single one cupped around the stem. It’s been like that for about 18 hours. Amnesia Haze auto. I was gonna bonsai it, so much wasn’t gonna come from it anyways
-
You can use some tweezers to slide in between the leaves and then separate them. One side of the leaves may get a little damaged but she will be fine.
1- View 1 reply
-
-
Deficiency, Toxicity, Wind/Light Burn, Root Issue? It’s an autoflower, I’m using grow dots in Coco Loco, i used the whole 75g pack(Too much?) in a 5gal pot. I water with my tap water and normally I would add cal-mag to it since I always end up with calcium deficiencies. I haven’t been using it with this one though, just adjusting pH. Some of…
-
This is an issue with potassium typically caused by under or over-watering coco. Usually under-watered. The curled down leaves are another clue. Nitrogen and potash are two elements that the plant needs in high amounts. When root hairs are damaged, they are the two symptoms most likely to show first. Grow Dots has plenty of potash so that’s…
1 -
Idk what to do. Maybe just ride it out and see what happens. Unfortunately I don’t really have time for the next few days to do anything.
-
-
slamfm posted an update 5 months ago
5 months ago (edited)
The fan leaves making a 5 point star was purely accidental. I didn’t even realize until after I made the cuts I wanted.
- Load More